(Early Noob SubC) Crystal and Bezel Installation Woes

  • Please add our email support@horologyboard.com and/or domain horologyboard.com into your whitelist to make sure emails are not filtered or blocked. If you have registered but have not received your activation email, please check you spam/junk folder. If you still cannot find your email to activate your account, please Contact Us. Thank you.
lpl

lpl

"Keanu Reeves"
Dec 23, 2017
79
115
33
Toronto, Canada
Hi all,

Recently attempted to replace a crystal on the SubC. Everything went well up until I was pressing the bezel back in place. After the bezel has been pressed in place, it is very tight and would not move. Does anyone know this issue and the remedy to it?

Thanks a lot
 
TickleShoes

TickleShoes

Member
Mar 8, 2018
12
13
3
Is it gen spec with the retainer ring and hytrel gasket? I’ve seen some that (believe it or not) can’t be fully pressed down or they’re too tight. Maybe undo the retainer a tad and it should. Be fine.
 
You must log in or register to reply here.
Top Bottom